Satsana Ender 3 Fan Duct with BLTouch/CRTouch, LED Bar, 5015 Fan & 4020 Fan

thingiverse

This is a remix of the Fan Duct remix by DWO that was originally created by eric-anastas. I also remixed the cap and added a LED bar and cover for a 4020 fan. The following is the changes I made to the Fan Duct Corrected the width of the 5015 Fan port as it had a gap that would allow air to escape Added support for the CRTouch as the cable outlet is in a different location. I had to remove the center hole that allowed removal of the pin on a BLTouch due to the spacing being too close to the CRTouch cable hole. Added 2mm to the BLTouch/CRTouch arm since it was too far away from the bed. I was at an offset of -0.60mm which was too close for my comfort. Now I am at -2.60mm. I liked the indent to make it easier to screw the Fan Duct in but it was still a little hard so I increased the angle a bit more. I increased the depth of 3 of the fan screw holes to allow longer screws. Top right was not increased as it would go though the cable channel. The cable cap was changed to allow the LED cable to fit through. I created a fan cover for a 4020 fan so that the fan is not exposed. I also included one that has a LED mount. You can route the cable through the cover and through the cable channel on the fan duct. I did not create any holes on the LED mount since there are a bunch of options. I just drilled my own for my Neo Pixel bar. The fan cover is held with two fan screws that are included with Noctua fans. The BLTouch/CRTouch offset remains the same at X=-54.3 Y=-18.2 I have everything oriented in the best position to print. The ones printed in my photos was not printed that was as I wanted the face of the Fan Cover to be the top so it was more wasteful with the supports required to print flipped. If there are any requests for the fan cover for the stock fan I will probably make it but for now I did not have the need for it so I did not make it. I could not think of a simple way to route the cable yet which was the primary reason to not bothering.