Satsana Ender 3 Fan Duct w/ BLTOUCH-5015

thingiverse

A heavily modified version of Eric Anasta's Satsana Ender 3 Fan Duct by Ammar Yasir has been created. This updated design includes a BLTOUCH mounting space, as well as room for a 5015 blower fan. A pressure clip on the right side is intended to counteract issues where the duct would sit flat on the X-carriage. Clearances were also checked at the printer's far right to ensure the BLTOUCH can probe the entire bed while avoiding interference with the stock belt tensioner. A small hex hole is located on the back of the fan duct for securing the bltouch mount using an M3 hex nut. This modification has not been thoroughly tested yet due to a lack of access to a 5015 fan. Printers are advised to exercise caution and report any issues encountered, which will be promptly addressed.