Satsana Ender 3 Fan Duct for CR-Touch

prusaprinters

<p>This is a modified remix of the Satsana Fan Shroud/Duct by eric-anastas for the Ender 3 Pro. This shroud is modified to fit with the Creality CR-Touch touch sensor, using the standard hardware that comes with it.</p> <p>Printing:</p> <p>Take note of the printing picture above. You will need to use a block object to prevent support generation on overlap, so that the bottom connecting sections will be supported only.</p> <p>I printed this at .16 layer height, but im sure .2 would do just fine.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3 Pro</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>200</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>38</p></div> <p><strong>Filament:</strong> Overture PLA Post-Printing =============</p> <p>Post Printing - using an exacto blade or razor to remove the supports from the connecting sections seen in the image below. This will allow room for the Cr-Touch bracket to install properly.</p> <p class="detail-image"><img src="https://cdn.thingiverse.com/assets/35/f1/8e/23/9d/remove_support.png"/></p> </p></p></p> Category: 3D Printer Accessories