Satsana Ender 3&5 BLTOUCH / EZABL / 5015/ UNIVERSAL Duct Fan

thingiverse

Note multiple versions are available for selection. *-If sensors are not installed, download the Ender 3 Fan Duct Flat Front Finish .stl file and G-code, optimized for printing with PLA at 200 degrees and a 60-degree bed.* ******************************************************************************************************* - Update June 10, 2020 Temp removed the file to tweak the design further. To avoid wasting your time and money. *-Add a UNIVERSAL FAN DUCT MOUNT that can be downloaded and used as usual or modified with an BLTOUCH by printing the BLTouch Bracket and attaching it. LOOK FOR THE UNIVERSAL FILES IN FILE FILE SECTION.* ******************************************************************************************************* Upcoming is the EZABL Bracket. ******************************************************************************************************* *-Add a Detachable BLTouch mount for Direct Drive* Files are available. - (BLTouch DETACHABLE FAN DUCT BODY) - (BLTouch Detachable Mount) *-G-code includes 200-degree temperature and 60-degree bed settings, but you can adjust them on your printer as needed.* Note: This is an early release. The stock Ender 3 gap from the nozzle to the underside of the BLTouch body is 8.3mm, not the probe distance. ******************************************************************************************************* *-EZABL.stl* Update June 9, 2020 *-Make a minor design change on EZABL.stl to move the hole slightly left to provide clearance for tightening locknuts.* ******************************************************************************************************* - Update June 3, 2020 *-Add Direct drive with EZABL sensors. Two versions are available: sensor on LHS and sensor on RHS.* G-code is included in the files. Files and photos can be found in Thingiverse Gallery. File Names: (EZABL_LHS_SENSOR__Direct_Drive.stl) - (EZABL_RHS_SENSOR_DIRECT_DRIVE.stl) ******************************************************************************************************* *-Update June 6, 2020* *-Modify 5015 Fan with BLTouch mount to allow sensor connection facing backwards.* STEP File is included. File name: (-5015_Fan_Duct_with_BLTOUCH.stl-) *-Update June 1, 2020* *-Add a BLTouch mount with a 5015 Fan mount.* Note: This model is based on drawings found online and has not been tested. If you don't have a BLTouch, you can still use this with a 5015 fan. ******************************************************************************************************* - Update May 31, 2020 *-Add EZABL Mount Body* File name: (EZAB_MODELL.stl) *-Note*: You need to know how to set offsets in Firmware. A YouTube video on offsets is available at https://www.youtube.com/watch?v=y_1Kg45APko I have attached a PDF file in the Files section to setup the BLTouch. x offset: -35.8mm Y offset: -2.5mm This is a remix of the fan duct for Ender 3. https://www.thingiverse.com/thing:4369859 All files, including G-code, are included. You can print directly from G-code or recommend opening it in Cura to see how I set up my supports. *-This project is still in progress, so use at your own risk.*