Satsana Dual 5015 - Proximity Sensor Mount

Satsana Dual 5015 - Proximity Sensor Mount

thingiverse

Small adapter plate for a M12 proximity sensor, Amazon link here.Printed in 5 minutes, this bolts directly to where the BL/CR touch mounts. Longer M3 screws were needed, I used M3x10mm. I wish I had made the mount a bit lower, as I very high up on the mount.This fits my Aquila with a custom x-endstop. Should fit Ender 3 just fine. I hope to move the probe over to the right side in the future, as I am missing a good part of the right side of the bed. Klipper printer.cfg [probe]pin: ^!PA7x_offset: -67y_offset: -11 Wiring The probe has 3 wires:Brown is +5vBlue is groundBlack is the signal wireTake 5v from the BL-Touch connector, It should be the second from the left of the motherboard. The ground and signal will connect to the Z-Endstop pins, ground being the pin on the left. (If unsure, please check with a multimeter).We will not need a diode unlike other probes due to the probe being 5v.

Download Model from thingiverse

With this file you will be able to print Satsana Dual 5015 - Proximity Sensor Mount with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Satsana Dual 5015 - Proximity Sensor Mount.