Satsana Dual 5015 Fans Remix for Ender 3 / Ender 5

thingiverse

Remixed with the following changes: 1) Turned the second 5015 fan around to intake air from the outside instead of directly over the hot end. 2) Reduced the screw hole sizes to allow M3's to thread in if necessary. 3) Reduced the length of the front end because it was bumping into the top rail on my Ender 5. It is still very close, and on in the corner it brushes up against the corner brace at the 219-220mm area, but this just causes it to canter up slightly and doesn't really affect the print.