Satsana-Drop a Dual 5015 fan duct for ender 3 v2 with support for BMS Dragonfly and ADXL

thingiverse

I was intrigued by the bltouch placement of the DropnDuctor, most dual 5015 fan duct have the sensor way to the side so it can't reach the whole bed on the other side. However the fan ducts where badly designed so I took those from a Satsana design and remixed them together in Tinkercad. Features of this design: - Dual 5015 Fans Screwless - BMS Dragonfly or Stock Creality hot end ( there are two models to download, Dragonfly BMS won't fit in the Stock model but vice versa is possible ) - Bltouch close to the nozzle so there is no effect of a slanted gantry (but can't reach 4cm of the back of my bed) - ADXL 345 mount option - Lightweight ( CURA says 51 gram ) - Extra mounting point on the right side of the model underneath the wheel. If you have stock creality hot end but the cheaper and smaller bltouch clone, use the BMS dragonfly model. Otherwise it can't reach the bed before the nozzle. If you want as much speed with Klipper, this model might be a good fit!