Satisfyer Pro2 Next Generation Docking station

prusaprinters

Don't leave your Satisfyer pro2 next generation lying around on your bedside table, but put it in the docking station so that the satisfyer is always charged and ready for use.NB! This docking station is suitable for the Satisfyer Pro2 Next Generation and therefore not for the Satisfyer Pro2 Vibration that does not have the charging connection at the bottom.Assembly: Insert the USB plug from above into the hole for the charging magnets and pull the cable through until the charging head is secured with magnets in the bottom of the docking station.Make sure that the SF mark on the charging head faces the front of the docking station. If the charging head is placed the other way around in the station, the Satisfyer will not charge and the charging head must be turned over.When the charging head is properly secured in the docking station, hook the wire behind the recesses of the cable tray to the rear of the docking station.Plug the USB plug into a USB charger and place the docking station on a flat surface, for example on your bedside table. The docking station is then ready for use.Insert the Satisfyer pro2 next generation with the buttons and SF sign facing the front into the docking station to charge the Satisfyer pro2 next generation automatically.I hope you'll be satisfied with this.Filament: Preferred ABS due to smooth finish, but any other filament is suitable.Nozzle: 0.4Layer height: 0.2 mm, qualityFilling: 15%Support: Not necessary Satisfy me with a cup of coffee