SATA Power Rail

thingiverse

This little box converts standard SATA power cables into power rails for case builds. Mount it in the case and run individual power extensions to your devices. Insert female connectors into slots, then glue retaining bridges over the back to keep them secure. Be careful not to get glue on the connector itself, allowing easy removal if needed later. Bend cables down to fit within the enclosure, using hot glue for support. The case has pre-cut holes for 8X3mm magnets. Cables can be pulled around, causing the rail to shift, so use a few drops of hot glue to hold it in place. Once all cables are run and secured, the rail should stay put. Magnets work well for temporarily holding the rail in position until you get everything sorted out. Remember to leave enough front clearance for SATA power cables.