Sapphire Pro/Plus Hotend Rear Cover

thingiverse

This is a cosmetic upgrade for Two Tree's Sapphire Pro/Plus Hotend. This will hide those ugly wires and give support on top for those wires. **Do NOT forget to install the spacer, this cover will prevent your Y axis from homing because the rear cover will prevent your printer from touching the limit switch** You will need to buy the following screws: **Materials** - 2x M4x8 (to attach spacer) - 2x M2x4 (to attach rear cover to top piece) - 4x M3x4 (for wire harness bracket) **Install Steps** - Install spacer first - Install top piece - Remove the 4 rear screws from the fans and the top 2 screws that hold the hotend onto the carriage - Screw those screws into the rear cover - Place the rear cover in-place and tighten screws - Place caps over the holes on the rear cover, and attach the rear bracket onto the wire harness