Sapphire Plus Mosquito Hotend Mount with ABL Support by ideagen3D

thingiverse

Remixed from [R31L4ND's E3D V6 Hotend Mount](https://www.thingiverse.com/thing:4337458) for the Sapphire Plus to better support the Mosquito/Spider & clone hotends. The collar and BLTouch mount have not been changed - feel free to re-use R31L4ND's. BLTouch: define NOZZLE_TO_PROBE_OFFSET {0, -43, 0 } Static: define NOZZLE_TO_PROBE_OFFSET {0, -48, 0 } ###Summary of changes: Reduced length of ducts (Mosquito Hotend is slightly shorter) Increased "height" of the 2 slots on top where you can drop nuts into, increases compatibility with thicker nuts. Added a mount for static ABL Probes (Inductive or Capacitive), 12mm diameter probes. Added a reinforcement bar to minimize flex when printing at super high speeds and avoid breaking during installation. Added optional 5 mm 'spacer blocks' - the mosquito hotend is noticeably taller than the stock, so depending on your bed and where you've mounted the Z endstops, even maximally tightened screws may not be enough. If this is you, stick this spacer block with double-sided tape to the bed brackets underneath Z endstops. You will need 2 of these, 1 for each side.