Samurai Helmet wearable

thingiverse

Hey there Folks! I've been itching to share this project with you all for quite some time now, so here it is. This fully wearable helmet has a bowl size of approximately 200mm, so feel free to scale it up or down as needed. Keep in mind that this print job can be quite lengthy, with each part taking around 1 hour and 30 minutes to complete at a print speed of 0.25. To ensure the best possible results, make sure to orient your parts accordingly. I found that printing the peak on its two ends yielded the most impressive outcome. You'll also need to add supports for most of the parts, but they're relatively small and shouldn't be too much trouble to remove. Some parts are self-explanatory, like the "Front plate x3.stl" which requires you to print three copies - otherwise, just stick with a single copy.