Samsung Wireless Charger Stand

thingiverse

I made a new version of the design for my wife's Samsung Galaxy Note 5 with the wireless fast charger (model EP-PN920). This new design is slightly smaller and has a different shape than the older non-fast version. I created it because my wife wanted to watch Netflix in bed while her phone was charging without having to hold it. The design also works as a bedside clock if you turn on daydream in Android's display settings. You can set your phone up either in portrait or landscape mode. The Note 5 is quite tall, so if you're using this design with a smaller phone, I recommend lowering the hole section by a few mm or raising the base points of contact. With my Galaxy S6, it was on the edge of detection in both portrait and landscape modes. Here's the link to the Tinkercad file where you can modify the design: https://www.tinkercad.com/things/1kN9UPh1wjZ I'm currently working on version 2. I've reduced the width and dropped the charger down a few mm so it works with more phones. You can play around with it here: www.tinkercad.com/things/9K8pJOggG5B. When this design is ready, I'll remix the original and link it back here. Version 2 with a cover can now be found here: https://www.tinkercad.com/things/1iTt6qQjqjq As for printing settings, I recommend using no rafts or supports and a resolution of 0.2mm. Infill should be set to 20%. I like using brims for long prints, but if you're confident in your adhesion, they aren't necessary.