Samsung TV Spacer for MU8000-Series

thingiverse

This remix of Joky's Samsung Spacers was created specifically for the MU8000 series TV. I own an UN55MU8000, which is identical to the UN55MU8000D/UN55MU8000FXZA. According to the official Samsung Guide, the M8x45MM screw is required for mounting on the UN55MU8000 model. Joky's original spacer was 2.5mm shorter than mine, as his TV is a K55. To compensate, I added 3mm to the top. Original Spacer from Joky: 31.5 mm This Spacer: 34.5 mm I manufactured mine using PLA filament with the following settings: 0.4 mm nozzle 0.2 mm layer height Five perimeters (wall thickness of 2mm) - As Joky suggested, I didn't use infill; instead, I printed it entirely solid with perimeters for added strength. To smooth out the print and allow the screw to pass through easily, I ran a drill bit through it. If you prefer not to do this, you can increase the size by a few percent. I would rather have a slightly oversized spacer that can be trimmed down than one that is too small and may come loose over time. I'm listing this separately so that anyone searching for MU8000 spacers can easily find it. These spacers are incredibly robust due to their all-perimeter construction without infill. I tested them using pliers and even jumped on them, but they wouldn't break. This is the result of using all perimeters and no infill, which may have a bearing on their durability.