Samsung Mediastation

thingiverse

A mediastation primarely for a Samsung watch and a phone. I used a basic Galaxy Watch charger, and a Ø = 90mm chargingpad. BASE: Upscale by about 5%. Print upside down for best results, this is faster since there is less supports. COVER: Upscale by about 5%. Print upside down, no supports needed. WATCHTOWER: Print with the watchface facing down, no supports needed. COVER WATCHTOWER: Print outside facing down, so the wire channel dont need supports. Screws needed: x4 M3 x 9mm for the WATCHTOWER -> WATCHTOWER COVER (M3x10mm works, but be careful so you don't damage the front.) x1 M4 x 25mm for the BASE -> WATCHTOWER x4 M3 x 10mm for the COVER -> BASE