Samsung Galaxy S6 Case

thingiverse

This is a design I created within Blender's software. The rear section doesn't extend fully through, but rather features a subtle impression (water cannot penetrate). I suggest utilizing ninjaflex filament for optimal results, as I'm uncertain if it will fit properly with non-stretchy filament. When inserting the device into its casing, ensure that the top portion (housing the camera) is placed first, followed by the rear section. Be cautious when handling the bottom part, as it is more fragile than the top. Print Settings: Printer Brand: Printrbot Printer Model: Simple Black Rafts: No Supports: No Infill Percentage: 35% Notes: To achieve the best possible outcome, print this design at a slow speed of 15mm/s or lower, as printing too quickly may compromise the quality of the ninjaflex material.