Samsung Galaxy S22+ S-View Flip Cover Car Holder

prusaprinters

This is a Phone mount for the Galaxy S22+ with S-View cover, I made this because i didn't want to use those magnet phone holders since the adhesive on the magnet might damage my case. Plus, the cover would constantly close while driving which is not ideal. I would recommend printing this at 20% infill, with a brim if using a glass bed, or if you have poor adhesion. This will also fit a Galaxy S21+ decently, although with a bit of play as the case and phone are rounded unlike the S22+. To insert the phone, place it around the tab as shown: Make sure not to apply too much pressure on this part otherwise it might snap off:=====================================================================Assembly:=====================================================================To attach the vent clip part to the main body, you need either superglue or hot glue. I would suggest using superglue but hot glue also worked fine in my case. Rotate the clip into the direction that fits your car's vent, then glue it in place. Make sure to test fit it before applying the glue since you can only do this once! If you opt to use hot glue and are using PLA filament, make sure you push the part where the glue is applied from behind so that it doesn't deform where the cover slides in.=====================================================================