Salt and Pepper Grinder Holder

prusaprinters

<p>We needed a salt and pepper holder that fit the following criteria:</p><p>(1) Right dimensions to snugly hold our current grinders that fit snug enough but with the right amount of tolerance to easily slip them in and out. &nbsp;Our grinders are just a hair shy of 2 1/8" in diameter - so if yours are the same or slightly less, this will work for you.</p><p>(2) Tall walls so there was zero chance of them flopping over or moving around (it is 1 5/8" deep).</p><p>(3) I liked the wire frame bottom that I saw in other designs so your falling grains would get collected down there without upsetting how it sits in the holder.</p><p>(4) I hated all the grinders with the big tall dingus in the middle that you're supposed to carry it by. &nbsp;Not only is it ugly but if you're going to use a hand to carry it, you might as well just carry the sturdy base not the flimsy dingus protruding 6" upwards from the middle. &nbsp;You can run a marathon with this sucker and the grinders won't fall over/out.</p><p>&nbsp;</p><p><strong>Printing Tips:</strong></p><p>The only thing worth mentioning is I chose to paint a seam on the ‘back’ for level changes. &nbsp;I didn't like how random level changes looked so I chose to hide the same away from view as it sits there 98% percent of the time.</p>