sally n brian

thingiverse

This lovely keepsake was carefully crafted with Tinkercad's online editor https://www.tinkercad.com/things/5UZxaZ4nh5y. Made especially for a dear friend and his beautiful spouse, it showcases a pedestal with their names intricately engraved on it, surrounded by a heart symbol that adds an extra layer of sentimental value. When preparing this creation for printing: * Raft settings: They don't significantly impact the outcome. * Supports: Like raft settings, they're not crucial in this design. * Infill density: Set to 35% to achieve a good balance between strength and print time, but it might be slightly too dense, depending on personal preference. For the perfect printing experience: * Use Pla with a 1.75mm diameter nozzle. * Heat the bed up to 90 degrees Celsius for optimal adhesion. * Adjust the extruder temperature to 210 degrees Celsius to ensure smooth plastic flow and quality prints. Note: Considering 35% infill might be slightly excessive, you may want to experiment with lower settings for a more lightweight print.