Saitek Throttle Quadrant Reverse Gates

thingiverse

This is a straightforward, rapid to print, modification to the Saitek/Logitech Flight Simulator Throttle Quadrant that introduces stop gates for the throttle approximately 25% from the lower range. This permits users to establish a reverse gate for throttle or a feather gate for propeller, as well as a cutoff gate for mixture. Easy to set up with X-Plane 11 and other flight simulators. I printed in PLA without requiring any finishing touches. The handle tops on the throttle can be removed to allow the part to slide down over them. Then you can attach the stop blocks using a single screw. No springs are necessary, as gravity takes care of holding the levers down until lifted by your fingers. WATCH THE VIDEO BELOW FOR A FULL DEMONSTRATION AND EXPLANATION