Sagrotan / Dettol Plug for Refill

thingiverse

I created a remix from a simple plug, but removing it proved difficult. To overcome this challenge, I added a small handle to the model courtesy of jojoslf. The prints come out fine even when using supports. To assemble the bottle holder, follow these steps: Drill a hole in the center of the top of the bottle. A cone drill works particularly well for this task. As noted by jojoslf with regard to the original design, it is essential to thoroughly clean out any debris resulting from the drilling process. The bottle may contain residual soap from its previous use. To remove this soap, wash the bottle repeatedly with small amounts of water. For a final cleaning, I employed a syringe to extract any remaining water from the bottle. Directly refilling the bottle with liquid soap worked effectively for me due to the minimal amount of water left in the container. Have fun creating.