Safety pin support for pin

thingiverse

Hello, This is a pin support made with a safety pin, made with a wide and plane contact area to be glued easily and quickly it to your item back face. First take mesure your "not moving part" of your safety pin and adjust the scale in slicer before printing it. (see photos to understand...) (For exemple for a 3.3cm total wide safety pin (standard) so 20mm of "not moving part" > scale stl to 89% , no support , no raft > go for 7 minutes of printing !) The printing time is so short , even with high resolution, you can retry with an other scaling pretty immediately.