Sabine Wren Helmet realistic

cults3d

This is my version of the Sabine Wren Style helmet. All pieces come apart and press fit. It prints nice and thick with room for pads. I printed this on a CR10S-pro with NO supports in the center but a added nice thick support for the widow peak is needed, very assential for good supports on the peak. The screens on the rangefinder can be printed in translucent. I would recommend gluing the pieces at final assembly. The range finder shaft comes with a cyclinder to mount it to the helmet that I labeled as BOLT. This can be replaced by an actual bolt, I created a hole all the way through the ear to allow more room but depending on the bolt size, you might need to adjust the hole. The alignment pins for the back piece fit directly into my own prints helmet holes, but you will need to trim the length. I made the pins long so they were easier to press into the back piece to glue and also easier to make sure the holes inside the helmet are cleared enough for them to fit. I myself like to insert the pins into the back piece, glue the pins, trim the pins, and then starting on one side, snap the back piece onto the helmet. Since the back piece is the same shape of the helmet but with pins, you'll have to flex it just a bit to get it to reach the last hole. Check out our insta and fb at GrizzlyMountainDesigns to keep up with our modeling and current builds! For even cheaper deals checkout our patreon.com/grizzlymountaindesigns This is a solid file that fits angled on my CR10s-pro bed (300x300) it is not split. Please, Do not share/resale the 3d model Please feel free to message with any other questions or reguests!