S5 Wall Phone Charger

thingiverse

Instructions Using the following options: charger diameter 3 units, z charger axis 5.8 units long, x charger axis 10.6 units across, left screw hole in charger yes, text reads 'toms phone', countersink for screws 3 times deep, device height 40 units tall, slack or buffer around the design 1.0 units wide, diameter of countersinking screws 3.85 units wide, right screw hole in charger no, thickness of the device walls 2 units strong, height of the base of the device 12 units high, text written using letters.dxf font set, modifier for vertical text placement on device screen 1 units away from standard, text displayed size 7 points large, back angle of the text on device 10 degrees at, outer band width around the text display 4 units wide, countersinking depth for screws in charger 10 units deep, inner angle or edge where the counter-sink starts forming at the screw 2 degrees at, depth of text below baseplate surface of the device 0.9 units away from it, slack space buffer for placement on mounting board for a standard phone with built-in antenna phone mounted height axis at position z = 11.6 and axis across the screen width at position x = 75 units, hole modifier that changes the hole size for this particular design choice 0, screw countersink diameter is modified from a smaller one of only 8 units