S3 Pattycake FPV Hovercraft / Tiny Whoov

thingiverse

Converting Your Quadcopter into a Hovercraft - Introducing the S3 Pattycake FPV Hovercraft! This version uses 6mm brushed motors. Check out this remix using 0603 brushless motors on Thingiverse. Features: - Prints in two parts, no support needed - Parts snap together seamlessly - Snap-in camera mount makes installation a breeze - Snap-in motor mounts provide secure attachment - Snap-in flight control board mount ensures stability - Slide-in battery mount allows for easy access - Weighs less than 38 grams with all components and battery, making it incredibly lightweight - No glue required - just snap and go! - No programming needed - plug and play simplicity - No wire extensions or additional soldering required Required: One of several common quadcopters, such as the Blade Inductrix, Blade Inductrix FPV, or any tiny whoop variation. Instructions: - Move your flight controller, FPV camera, motors, and propellers to the new S3 Pattycake frame. Ensure front motors stay in front (main body) and rear motors stay in rear motor mounts. - Note: Press in motors from the underside and rear of motor mounts. They will not push all the way through the mount, but instead sit just below the motor mount's top/front surface under a small lip. - When plugging in your motors, plug front-left motor into back-left port, back-left motor into front-left port, and same on the right side... this will keep your S3 Pattycake from spinning out of control. Piloting: - Use your throttle/yaw stick for everything - it's that easy!