S22 Shoulder Bolts Saver

thingiverse

if you switched out the original bolts for shoulder bolts, you can use these caps to secure them. both sides should fit very tight!! to prevent it from coming loose. not sure if normal TPU is stiff enough, i used Extrudr Hard TPU and it stays on pretty well. if you use TPU with rough particles like carbonTPU it will scratch off part of the red painting. used with nylon locknuts. it even stays on without srew-glue, but you should use both to be save. M8 shoulder bolts, shoulder diameter 10mm, length 30mm & 25mm bought the ones without the black head but i think they should be all normed and the same. print 2 long ones for the upper bolts and 2 shorter one for the medium bolts. haven't changed the lowest near the geometry screws. i included small caps to better prevent them from coming loose.pls print in tpu and screw or hammer them on, until i found a simpler solution or update.