S1 Endpoint 40mm

prusaprinters

<p>This RPI case is designed for high stress environments. Print it with 50% infill for most needs or 75% if you want to stand on it. It takes 40mm fans and has enough room for expansion board and additional side mounted hardware. It also sports a tie down strip incase you want to internally secure your side mount cables.&nbsp;</p><p>Everything is new user friendly with printing. The print difficulty is pretty much 0 as the only way you can mess it up is by having loose belts or a build sheet that isnt correctly heated.&nbsp;</p><p>Use thermal reflective tape below and above rpi, inside of case if its put in a low airflow location and you intend run it for long periods of time. This is not needed but it will help with keeping the print from sagging over time.&nbsp;</p><p>If you have any questions please post them here or reach out on twitter.&nbsp;</p><p>link in bio. &nbsp;</p><p>&nbsp;</p>