S.T.E.V.E E3DV6 Bowden Mount

thingiverse

Since I had plans to use a bowden setup with CompRevTech's S.T.E.V.E. printer, I designed these parts that bolt onto the extruder mounting plate. There are four versions: 1. Normal without radial fan setup and no mount for a 12mm inductive sensor. 2. Normal with a mount for a 12mm inductive sensor. 3. Radial 1 setup for usage of a radial fan and shroud from the Hypercube by Tech2c. 4. Radial 2 setup is the same as above, only difference is that it includes a 12mm holder for an inductive sensor. Version 1 and 2 move the extruder slightly further out compared to the Titan Extruder setup. Version 3 and 4 move it even further (10mm more than version 1 and 2) due to ducting. Version 1 allows usage of the dual fan setup as designed by CompRevTech, while version 2 is limited to one left-side fan due to inductive sensor setup. You can use the clamp Tech2C designed: https://www.thingiverse.com/thing:1752766 (E3D_clamp). Mounting hardware for versions 1 and 2: - Four M3x10mm with four M3 nuts. - Two M3x16mm with two M3 nuts (for the clamp). Mounting hardware for versions 3 and 4: - Four M3x10mm with four M3 nuts. - Two M3x16mm with two M3 nuts (for the clamp). - One M3x20mm with one M3 nut (not really required but can be useful) for the fan. - Two M3x8mm for the duct.