S&C

thingiverse

Customized version of http://www.thingiverse.com/thing:739573 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=739573 Instructions Using the following settings: Original Surfer font selected Glyphs are merged at 25 points Border width is set to zero Lug width is fixed at five units Plate lug style is chosen Extruder one is used for outlining Font with specific style is not defined Text extruder is assigned to extruder two Inner margin width is set to one unit Ruler unit is ten units Outline thickness is three point zero millimeters Lug length is fixed at four units Bar style is limited to bar only Border color is set to black Character spacing is adjusted to nine tenths of a unit Glyphs are merged using the bar and glyphs strategy Text thickness is set to four point two millimeters Trim from bar length is disabled Font size is twelve points Bar shift is set to zero units Bar thickness is fixed at two point four millimeters Bar width is set to five units Narrow font lines are not widened Writing direction is left to right Extruder one is assigned for bare fill Bar color is set to khaki Outline color is gray Font outline style is rounded Line five is empty Line four is empty Line three is empty Line two is empty Line one reads S&C Single extruder is selected for monochrome printing Extruder two is assigned for border filling Border thickness is set to three point six millimeters Minimal color layer thickness is fixed at zero point six units Line spacing is adjusted to one unit Text color is set to dark red Outer margin width is set to one unit Lug text distance is set to two units Font weight is set to zero Font outline width is fixed at half a unit