"S" Bend for 1/2 inch conduit

thingiverse

I needed a 1/2 inch conduit "S" bend for a specific project I was working on, but it also had to be short and have the correct offset. Offset: 22.6mm Angle: 40 degrees Run Length: 68mm Overall length: 100mm Finished weight: 20.1 grams Note that the "straight" sections at either end are only 16mm long. Standard 1/2 conduit fittings have a depth of 22.5mm. The 1/2 PVC conduit outside diameter is supposed to be 21.33 mm. Because of the expansion/shrinkage of the printing process as well as the ribbed nature of 3D printed parts, I found that a 22mm inside diameter was needed for the socket end to slip over a standard conduit. If it comes out a bit loose then I suggest increasing your extrusion factor by a couple of percent. If it comes out a bit too tight then reduce extrusion factor. Note that there is sufficient offset to "hop" over another run of 1/2 conduit. Also see: "Y" Split for 1/2 inch conduit: https://www.thingiverse.com/thing:2959008 "Y" Split for 3/4 to 1/2 inch conduit: https://www.thingiverse.com/thing:2959940