Ryobi Carpet Vacuum Beater Bar Replacement Part

prusaprinters

Seized carpet beater bar on your one+ ryobi stick vacuum? This is the part you need. Grab a 5mm inner bore, 16mm outer diameter bearing that is 5mm thick.Use some implement of destruction to separate the green thing from the gray thing, I recommend a hammer and pry bar, they'll be fused together good.Recover the bearing shaft, replace the bearing with your new one, then sand the brush bar flat, stick the shaft back in with some epoxy and press fit everything back together. The bearing is not on there particularly tightly, I was able to separate it from the shaft with a nail punch.The source freecad file is provided for your convenience so that you can fix it with the junk bearings sitting in your drawer.The carpet attachment is labeled P726 by ryobi and sometimes goes by HM-313280001 if you want to pay $100 for the whole thing. This paragraph is here for SEO so hopefully people who need the part can find it.There might be some useful information about this repair on this twitter thread. https://twitter.com/RealTimeKodi/status/1495163692291342343This description is a 1:00AM stream of consciousness prose and has not been proofread in any way.