Ryobi 40V Battery Holder for Rubbermaid Fasttrack Slat Walls

thingiverse

This holder is perfect for storing your 40V Ryobi batteries on Rubbermaid FastTrack Wall Slats. I printed in the orientation shown in the pictures to give the print greater strength, considering how heavy some of these 40V batteries are. In addition, I also printed personally at 75% infill, but I think you could easily get away with only 50% infill. I used support blockers on the decorative side that is facing down on the bed, and let it print without supports so it looked nice, and it printed just fine. But then as you can see I used tree supports in Cura (standard settings) to hold up the other side of the print, and that worked VERY well, it came off easy! The only complaint I have with it, is that the clip goes into the wall slat TIGHTLY. Not only do you need to give it a good push in, but also it's not sliding around or coming off without a fight. So make sure you put it exactly where you want it to stay. I might go back some time to stretch the clip out to make it a little easier to install/remove. If so, and it's successful, I'll update the file.