Ryobi 18V ONE+ Brushless Stick Vacuum Accessories

thingiverse

Adapter to allow connection of short piece of standard 32mm vacuum hose. Both adapters are print in place (except Clip). You will need to print them standing on the hose end and use no more than 15% interface density for the supports. This will allow you to crack loose the two halves once you cut through the outer visible supports between the two halves. If the infill support density is to high the two halves will never rotate separately. A 2.6mm pin will be required for the clip to pivot (glue pin to either the clip or the outer adaptor holes, obviously not both) and a piece of foam rubber (or spring) can be glued under the clip.