RX6R hard case

cults3d

Hard case for the FrSky RX6R receiver. Offers superior protection compared to the fragile card wrapper supplied, making the receiver suitable for high-value gliders and electric models. There is a hole for the bind button. A dot next to the connector indicates the CH1 signal pin. Note that there is no access to the S.Bus/SPort connector. The single STL file contains both top and bottom parts. Instructions: Print the two parts, remove the old card wrapper from the receiver, but don't discard it! Instead, cut off a piece 21 x 18 mm. This will be the new bed for the receiver board. Place the bed in the bottom part, place the receiver over the bed, secure the top part with adhesive tape, and support the antennae using silicone rubber or hot glue (low-temperature).