RV Storage Compartment Grommet

thingiverse

This is a "waterproof" grommet for passing a wire out an RV storage compartment hatch. The idea is you have one piece with a hole for the wire to pass through, one piece to plug the hole completely when you are not passing the wire through, and a nut to hold either piece on. Both pieces have a slot for a standard rubber washer you can get from the plumbing section at the hardware store but you will have to cut one of the washers to let the wire pass through. It is not gonna be 100% perfectly waterproof with either piece but it should be good enough. Just had a good rain yesterday and today and saw no water intrusion whatsoever Avoid printing with PLA since it will be exposed to a lot of sun The preset is for a starlink cable and a 1.25" hole in the bay door (1" thick door), but you should be able make little adjustments for different settings. UPDATE: Added an additional "filler" component. It is required to help the piece with a slot in it keep it's shape over time. See the new photo to see it in use NOTE: If you change the settings you may have to manually adjust the angle of the wire hole because I just eyeballed that, it is not computed