Russian MIG-15 Large model

thingiverse

Print this Russian MIG-15 model in 5 segments for simple assembly; it has a wingspan of 300mm. On a Replicator 2x, each wing takes approximately 2.3 hours at a 0.2 layer height without supports, the midsection requires around 3 hours sans supports, the tail section needs about 3.3 hours without supports, and the nose section takes roughly 3.3 hours with supports for the center intake piece. Avoid rafts and ensure good adhesion to successfully print these parts vertically (refer to image). Assemble by gluing the pieces together using epoxy resin; however, note that the segments could benefit from improved keying features.