Runners Bib Display Plaque

thingiverse

Display Your Running Achievement Collection on a Wooden Plaque Materials You'll Need - 8x10 Inch Wooden Plank - Two Screw-In Hooks - High-Quality Laser Engraver Such As Trotec Speedy 300 120 Watt Model Instructions to Use Turn On Your Trotec Speedy 300 120 Watt Laser and Adjust Settings According To The Following: Engarge Power at 90%, Speed at 100%, Hz At 500, With Air Assist Function Enabled. Next, Place Your Wooden Plank on the Engraver's Tray. Carefully Apply Heat, Pressure, And Time Required for Optimal Resultant Texture. Install Two Hooks By Inserting Them in the Pre-Drilled Holes Beneath the Etched Surface of Your Running Collection. The Process Should Be Accomplished Within Few Minutes Depending Upon The Level of Detail Desired and Individual Engraving Settings Used