[Runescape] Duellist's Cap T6

thingiverse

## Duellist's Cap From Runescape3 ---------------------------------------------------------- ### My Designs Are Fully Print-Ready, With All Detached/Floating Elements Securely Attached Using Small Rods That Are An Integral Part of the Model. ### I Have Created All My Designs at a Minimum Scale Equivalent to the Standard 0.4mm Nozzle, So I Highly Recommend Scaling Up the Models Before Printing. (They Should Print Just Fine at Their Default Scale If Your Printer Is Properly Calibrated.) ### All My Models (Except a Few) Require Supports Enabled for Optimal Printing Results. Additionally, I Suggest Adjusting the Following Settings: • Layer Height: 0.1mm • Support Horizontal Expansion: 1-2mm • Support Placement: Touching Buildplate • Support Roof: Enabled • Support Roof Density: 100% • Support Roof Pattern: Concentric ---------------------------------------------------------- ### Thanks for Taking the Time to Print My Designs, I Would Appreciate It If You Could Share Your Makes! ---------------------------------------------------------- ### Notes for This Model: • N/A