[Runescape] Drygore Longswords T90

thingiverse

## Drygore Longswords From Runescape3 ---------------------------------------------------------- ### My designs are fully print-ready, all detached/Floating elements have been attached using small rods that are now integral to the model. ### I've carefully designed all my models at a minimum scale of 0.4mm nozzle standard, so it's essential you scale up the models before printing. They should print perfectly fine at their default scale if your printer is properly calibrated. ### All my models (with only a few exceptions) require supports enabled during printing. For best results, adjust these settings: • Layer Height: 0.1mm • Support Horizontal Expansion: 1-2mm • Support Placement: Touching Buildplate • Support Roof: Enabled • Support Roof Density: 100% • Support Roof Pattern: Concentric ---------------------------------------------------------- ### Thanks for taking the time to print my models, I'd be grateful if you could share your creations with the community! ---------------------------------------------------------- ### Notes for this model: • N/A