Runescape Coaster - Fire Rune

prusaprinters

<p>I created several coaster models based on this model. &nbsp;The rest are on my profile.</p><p>I really wanted to print some Runescape themed coasters, but found that the models already out there were kind of bad. &nbsp;</p><p>Print with 20% infill for best results. &nbsp;PLA is fine.<br>Enable ironing on every layer. &nbsp;I printed these before I knew about this, so I have lines where the paint is.</p><p>I highly recommend using plastidip on the bottom to create a non-slide coating. &nbsp;Only one medium layer of plastidip is needed.</p><p>Use acrylic paint. &nbsp;Several coats of very thin paint should give good results. &nbsp;Some of mine turned out better than others. &nbsp;Still need to finish painting most of them.</p><p>Attached a photo with the various colors you'll need to match with paint.</p>