Runcam Split mount (

thingiverse

I designed a camera mount to pull the camera out from behind the props. This is an X frame, and the camera has a wide-angle lens, so not only can I see the props in high-definition footage, but I can also spot the motors. To prevent this, I relocated the camera to the top of the frame, putting it out of the way of the propellers. This setup is on my 275-inch quad with 7-inch props and 1600kv motors (long-range). I'm using a Runcam Split mount with a horizontal dipole antenna mount accessory. The mounting holes are spaced 38mm apart, and the 4mm hole size accommodates vibration-dampening rubber inserts used on Matek FC. I broke down this design into two parts because printing it in one piece would require supports and compromise its durability. After printing, I assembled the two pieces using CA glue.