Runcam split case

thingiverse

I wanted to add an FPV device to a tricopter I was building, so I chose the Runcam Split for its affordability over a GoPro. After some trial and error, the case finally came together. I likely used 30% infill, but it probably doesn't need that much support. To assemble the case, I utilized 14mm aluminum standoffs inside and M3 bolts to secure both the front and back pieces. Keep in mind that you may need to drill new holes for the camera mount as they might be slightly too small. The buttons were an afterthought but work well; just remember to install them upside down so they don't fall out. This design was straightforward and simple, with a wire exit point tailored to my gimbal setup. With minor adjustments, it should adapt easily to your needs. If you have any questions, feel free to ask.