Runcam Nano3 Camera Mount for Inverted Meteor65 Frame

thingiverse

This is a remix of the HappyModel Moblite7 canopy that I have adapted for use in an inverted Meteor65 build. In my case I have used a CrazyBeeF4 Lite flight controller from a Mobula6, but other CrazyBee variants would work as well. I have increased the height of the camera protection a bit to protect those original RunCam Nano3 lenses I have (and covet). Rotate the frame so that the USB port sits next to the angled brace (normally at the front of pre-built models) facing upwards and the battery runs east/west (toilet-tank). Adjust the FC orientation and motor mapping in Betaflight to suit. Insert the square section in between the front brace and the FC mount and then loop the tongue back through the square section and over the front post. Once this is done put the gummy over the post and mount the FC as usual. Gives a camera angle of about 35 - 40 degrees which is about right for acro racing (at least for me anyway). You can insert or remove sections using TinkerCad to increase or reduce the angle.