Ruixin Pro guide Rod Holder (For the updated & upgraded version of Ruixin Pro)

thingiverse

This is a Customizable Guide Rod Holder / clip rest for the Upgraded and updated version of the Ruixin Pro all-metal sharpener that can be purchased on AliExpress or Ebay. See link - https://www.aliexpress.com/item/32956547212.html Unscrew the small hex screw at the back of the sharpening rod guide, and insert the 3D printed part. (See my photos) Replace and tighten the screw. While sharpening, you can now move your sharpening guide bar out of the way and slide it into the clip rest holder. Very handy to keep it out of the way while rotating the knife, or inspecting your sharpening. The holder allows knife sharpening down to an angle of approximately 12 degrees before interfering with the guide rod. If you need to sharpen to a lower angle, then either flip the mechanism around so the holder is facing up and towards you, or just remove the holder if you prefer. UPDATE: Updated to make it more durable. NOTE : If you want to use my Fine Tuning adapter, then check out the link below. Be sure to select your 8mm or 7mm size vertical rod and select the file with the "Extension Tube" to be able to clear and not interfere with this Guide Rod Holder. https://www.thingiverse.com/thing:3644585 Some more of my other designs: https://www.thingiverse.com/leadingedge/designs