Ruffwear dog light

thingiverse

LED lighting system for Ruffwear dog harness. Revisions: led_clip_rev1 - revised buckle clip, added strength, with better flexibility. Machine screws/nuts, Phillips pan head, Stainless steel 18-8, #2-56 x 1/2" - (boltdepot) 2x- Cree XPG3 white LED, 2x- Cree XPE red LED $12 (ebay) http://www.ebay.com/itm/222196133904?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT http://www.ebay.com/itm/261513081617?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT Glow inc V10 ultra green powder/clear epoxy $12 (amazon) 2x- AMC7135 constant current LED driver 2x- $9 shipped (ebay) http://www.ebay.com/itm/221670556427?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT Each AMC7135 chip on this board supplies 350mA. The board will supply 2+amps, so one must desolder a couple of these 7135 chips, taking it down to the preferred maximum amp draw. The momentary switches are connected in parallel with the onboard switch. 23x23x10 extruded aluminum heatsinks 20x-$3.50 shipped (ebay) http://www.ebay.com/itm/252568509163?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT 2x- 16mm momentary push-button switch dome top (white/red) $14 shipped (ebay) http://www.ebay.com/itm/321483308331?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT http://www.ebay.com/itm/221515004108?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT Gold plated USB cables - $4 shipped (ebay) Driver base hooks to harness, driver base also uses paracord to secure base to white LED housing. Cord is threaded through the holes, and then melted at the end making it unable to come loose. Features independent control of white and red LEDs, 4 brightness modes, as well as SOS, flash. Uses Nitecore F1 18650 powerbank, which is rated at a 1-amp output. Both battery and powerbank have protection circuits for safety of the dog, as this design is not waterproof, and shouldn't be used in the rain or anywhere it could get water on it. The white LED driver is set at 700mA current limit, and the red is set to 350mA current limit giving a total of 1050mA current draw when both sets of LEDs are at maximum brightness. I have used a thermal imager and the heatsinked driver boards, and heatsinked LEDs remain at a safe temperature. All parts were made with T-Glase, although ABS or a more flexible filament might be the optimal choice for the buckle clips.