RUDE NIGHT LIGHT - MIDDLE FINGER LED LIGHT

cults3d

NOTE: COPYRIGHT PA1© - SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS: https://www.patreon.com/PA1_MAKER This one was a request from one of my followers! An easy print with a clear message! :p -Fits Prusa mk3s and Ender serie -Can be scale down by 0.66 (or 66%) to have a smaller light which fits a prusa mini bed. You'll need to replace hardware (see note below), The file is completely redrawn in my 3d software, (not a STL made from SVG) and the line widths are made with 3d printing in mind and to scale the model easily without troubles. -No need for transparent/clear filament -100% support free -Easy to print/assemble -Full access door at the back INSTRUCTIONS: You will need (5x) M3X6mm screws (imperial 6-32 equivalent will work too) Print one of each part following those recommendations: For the light box and the backplate: Use a 0.3mm layer height for a reduced print time. FOR THE MIDDLE FINGER SILHOUETTE: Use a normal filament, the color of your choice, for the base layer. You don't need to use a tranparent or clear filament, the face is thin and let the light easily shine through. Use a 0.2mm layer height. You will have to change filament color with a pause at height (Or color change, the one you prefer) at the corresponding layer. Once everything is printed, glue the face to the light box and install your led strip inside from the back. When finished, simply close the backplate and the assembly is done! IF YOU CHOOSE TO SCALE IT DOWN FOR THE PRUSA MINI: Use a scale factor of 66%. You will have to replace the M3 screws with M2 screws instead, or slightly drill the holes to the initial M3 screws hole (3.4mm for the backplate holes and 2.8mm approx for the lightbox holes. If you have any questions, just ask! I will try to help as much as i can!!! Have fun!!!!