Rubiks Void Part

myminifactory

This is a particularly tricky section I managed to damage on my Rubik's void cube. It was quite challenging to design in Fusion 360, but after five iterations, I finally created one with tolerances precise enough for it to work smoothly. Due to the manufacturing process used to create the original part, there's a small hole at its bottom. Three-dimensional printing doesn't require this opening, so this component should be stronger than the original. I utilized my Monoprice Maker Select to print this and applied high-density support underneath the arch because of the tolerance issue, which necessitated some post-print cleaning up with a knife to allow it to slide smoothly into place.