RTIC or YETI Two Piece Handle

thingiverse

I needed a custom-printed handle for my RTIC cup but couldn't print some of the other available options due to bed size limitations. This particular design is made in two pieces, allowing my MP mini to handle it with ease. To assemble the piece, you'll need at least a 1" long 1/4" bolt along with a nut. A small protrusion from the hoop fits into a keyway in the handle to prevent spinning. I printed both parts at around 60% infill for optimal heft and strength. The handle was printed upright, but the quality could have been better if it were printed horizontally with supports. After some inside sanding, the print fit my RTIC cup perfectly. I tested it on a friend's YETI mug and found that it didn't sit as high; you may need to scale it up by a few percent to get your desired height.