RT ELBOW (beta)

thingiverse

RT ELBOW system lets users with insufficient wrist mobility utilize a Wrist Powered Hand Prosthesis, as they have sufficient forearm strength to operate one. The RT Elbow must be thermoformed after printing and assembled with a socket and two tension support tensors. The RT Elbow features a two-wire tensor socket, requiring the use of an RT Whipletree to distribute tension forces across four fingers, not the thumb, for enhanced grip (BETA VERSION - PLEASE SHARE YOUR EXPERIENCE). RT Wires Guide is an optional component that provides wire order but isn't essential for operation. To utilize it, simply attach it to the end of the gauntlet; attachment methods vary depending on printing material. For PLA, chloroform or super glue works best, while ABS requires acetone. Be cautious when handling these chemicals - read safety information before use and proceed at your own risk. Best regards from Chile! Print Settings: Printer Brand: RepRap Printer: Prusa i3 Rafts: Doesn't Matter Supports: Yes Resolution: 0.1mm Infill: 50% Notes: To print RT Elbow, rotate it 5-15 degrees to fit a 200x200 bed. Post-Printing: RT Elbow must be thermoformed after printing. To achieve the desired curved shape, soak the PLA in hot water (BE CAREFUL). Use padding in areas of skin contact for comfort. Custom Section: WARNING: Stop using this component if skin irritation occurs or its use causes discomfort. By using this component, you acknowledge that I'm not responsible for any damage it may cause and release me from liability. Watch RT Elbow in action with K1 Hand below: RT Elbow RT Elbow + K1 Hand RT Elbow + K1 Hand: The Cookie Test!