RPi4 Armor Case Dual Fan - Noise Riser

thingiverse

I found the dual fans a bit loud on the the RPI4 armor case. They work better if they're lifted a little off the aluminum case. This model should print: 50mm long 24.4mm wide 1.4mm high If you see red on the base or the height shows as 1.5mm... just drop Z down by -0.1mm. Some slicers may have trouble with positioning and may give an error, but it prints fine. You need to allow it print thin walls. Also a great test for bed adhesion. Printed on the Ender 5 with glass bed coated and a thin layer of sugar water (no brim or raft needed). Wait for it to cool. It's thin enough to warp if forced off the bed. Filament: esun PLA+ Purple Nozzle: 205 Bed: 60 (glass) Slicer: Cura Layer Height: .12, .16, .20 (all work well) Design Tool: 3D Builder